User Manual

page 20
3. Select Property Value with Right Dial: There are
two ways to select the property value with the right
dial.
a. Fine Adjustment: Press the right dial in
slightly, then continue to press in the dial while
turning in either direction to change the active
property’s value by increments of 1. (The
exception is Color Temperature, which adjusts
in increments of 25).
b. Coarse Adjustment: Turn the right dial in either
direction. The active property’s value will
now change in increments of 10 (with Color
Temperature incrementing by 100).
NOTE: Local Mode will always default to the last setting it had
before being turned off.
DMX MODE INSTRUCTIONS
1. Connect DMX Board: Connect your DMX512-
compliant device to the Wasp 100-C™ via the DMX
“In” Socket on the right side of the Control Panel
2. Engage DMX Mode: Flip the DMX Mode On/
Off Switch to the up position, causing the DMX
indicator light to turn on. This light tells you that
you are now in DMX mode and can use a DMX
board to control the light. Your digital display will
look like this and will register value changes via the
connected DMX board.
3. Adjust Starting Address: You will also notice that
there is a fifth symbol when in DMX mode - “A”.
This indicates the light’s starting address, and
its value determines which controls on the DMX