User Manual
page 18
NOTE: Remember that the light uses 80W per second when at
full output. This requires a battery with a minimum power rating
of 90Wh, although we recommend batteries rated for 100 Wh or
higher and with a minimum 10 amp hour fuse. Exact run time is
based on the individual battery’s storage capacity.
Firmware Updates
The Wasp 100-C™ is designed to receive periodic firmware
updates, which will be made available via Hive. Once
notified, connect your unit to your computer via a USB
cable using the USB port in order to complete the firmware
installation.
Perfect S.H.O.T.™ Controls
The light emitted by the Wasp 100-C™ can be configured
via Hive’s Perfect S.H.O.T.™ system, which controls these
four properties:
• Saturation (denoted by “S” on the display)
• Hue (denoted by “H” on the display)
• Output or Dimming (denoted by “D” on the display)
• Color Temperature (denoted by “K” for degrees in
Kelvin when in local mode, or by “C” when in DMX
mode.)