User Manual
page 17
Power
ONLY use 24VDC Power source within acceptable
voltage range of 12-34V DC.
There are two options for powering the light:
AC/DC ADAPTER (INCLUDED):
1. Connect the provided AC/DC adapter to the light
via the the 4-pin XLR cable (XLR pin wiring pin
1 - DCV In and pin 4 + DCV In), which is inserted
into the corresponding power socket on the light’s
control panel.
2. Connect the adapter’s power cable into the wall or
to a generator.
3. Turn the Wasp 100-C™ on by flipping the power
switch to the “on” position (up), located on the
control panel, causing the power indicator light to
illuminate.
BATTERY (SOLD SEPARATELY):
1. Attach the battery’s Dtap to 4 pin XLR adapter
cable to the battery, with the other end connecting
to the light via the power socket in the control
panel.
2. Turn the light on by flipping the power switch
to the “on” position (up), located on the control
panel. This will cause the power indicator light to
illuminate.