User Manual

page 15

ATTACHING THE BARNDOORS

The barndoors can allow for greater control in shaping the

light. To attach:

1. Rotate the top clip until it is parallel to the reﬂector

face

2. Slide the barndoors into the reﬂector cage’s outer

lens stage, or slot.

3. Rotate the top clip back into its locked position.

4. Adjust one or more of the leaves (i.e. “doors”) of the

barndoors to cut or shape the beam of light emitted

by the Wasp 100-C™.

REMOVING THE REFLECTOR

The reﬂector and the cage that it sits in can be removed

from the housing in order to accommodate a different

accessory, such as an alternative reﬂector or softbox.

1. Press ﬁrmly on reﬂector cage and twist

counterclockwise to release reﬂector plate from

locking pins.

2. Rotate counterclockwise and pull loosely until free.

3. To reattach, center the reﬂector’s keyed grooves

over the housing pins, insert, and rotate clockwise.