User Manual

CONTROLS / LOCAL CONTROLHIVE LIGHTING33 34
LOCAL CONTROL
1. Engage Local Mode: Flip the DMX On/Off
Switch to the down position, causing the DMX
light to turn off. You are now in LOCAL MODE,
and the digital display will look like this:
2. IMPORTANT: In local mode, color temperature
is indicated by the letter “K” because the color
temperature range of 1650 - 8000 is in Kelvin.
3. Select Property With Left Dial: Turn the left
dial in either direction to toggle through the
four properties.
4. Select Property Value with Right Dial: There
are two ways to select the property value with
the right dial.
5. Fine Adjustment: Click the ADJUST dial in
once if in coarse control, then turn in either
direction to change the active property’s value
by increments of 1. (The only exception is Col-
or Temperature, which adjusts in increments
of 25K).
6. Coarse Adjustment: Click once if in fine
control then turn the ADJUST dial in either
direction. The active property’s value will now
change in increments of 10 (with Color Tem-
NOTE: Local Mode will always default to the last setting it had before being turned off.
perature incrementing by 200K).
7. Dial Lock: The local control dials can be
locked to prevent accidental changes in the
settings of the light. To lock the dials push
and hold the ADJUST knob for four seconds
until a small lock icon appears on the bottom
right hand corner of the OLED screen. To
unlock the dials again push and hold the AD-
JUST knob for four seconds until the lock icon
disappears.