User Manual

POWERHIVE LIGHTING27 28

ONLY use Hive Lighting provided power supplies with the

C-Series lights. Each C-Series ﬁxture has a speciﬁc power

supply and CANNOT be used on other models. There are

two options for powering the light:

POWER

1. Connect the provided AC/DC adapter to the

light via the the 4-pin XLR cable (XLR pin wir-

ing pin 1 - DCV In and pin 4 + DCV In), which is

inserted into the corresponding power socket

on the light’s control panel.

2. Connect the adapter’s power cable into the

wall or to a generator.

3. Turn the ﬁxture on by ﬂipping the power

switch to the “on” position (up), located on

the control panel, causing the power indicator

light to illuminate.

1. Attach the battery’s D-Tap to 4-Pin XLR adapter

cable to the battery, with the other end con-

necting to the light via the power socket in the

control panel.

2. Turn the light on by ﬂipping the power switch

to the “on” position (up), located on the control

panel. This will cause the power indicator light

to illuminate.

AC/DC ADAPTER (INCLUDED)

BATTERY (SOLD SEPARATELY)*

BEE 50-C:

WASP 100-C:

HORNET 200-C:

12VDC Power Source within acceptable

voltage range of 12-18V DC.

12V, 14.4V, 14.8V (60Wh or higher)

19VDC Power Source within acceptable

voltage range of 12-20V DC.

14.4V (90Wh or higher)

36VDC Power Source within acceptable

voltage range of 24-36V DC.

14.4V run in series*, 26V, 28V (160Wh or

higher)

* NOTE: Only use Hive Lighting’s Y-Cable adapter for running 14.4V batteries in series to

the Hornet 200-C. Only use two of the same battery packs and ensure that both packs

are fully charged before using.

* NOTE : Exact run time is based on the individual battery’s storage capacity.

AC/DC:

Battery: