User Manual

C-SERIES ACCESSORIES / MOUNTINGHIVE LIGHTING23 24
SAFETY CHAIN ATTACHMENT
POWER ACCESSORY MOUNT
PHOTO YOKE
A standard safety chain may be attached to
any C-series Light either through a key ring on
the Standard Yoke tab, or through an eye bolt
with 1/4”-20 on the light’s interface
Both the Standard Yoke and Studio Yoke have
mounting tabs 180 degrees apart, at 90° and
270°, on the outer diameter of the yoke. These
tabs allow for a variety of power accessories
to be mounted directly to the C-Series fixture.
The primary accessories that can be mounted
here are the Power Supply Mounting Bracket
and the Battery Plate mount.
To mount power accessories to the yoke, use
the receiver tab on the back of each accessory,
which mates with the mounting tab on the
yoke. The receiver tab has a pull pin lock, pull
up on the pin lock until the pin fully clears the
receiver tab. When the receiver tab is clear,
center the mounting tab on the yoke inside
All C-Series lights may be operated with
the Photo Yoke when securely mounted
to a separate apparatus, such as a stand
(purchased separately). Carefully position the
light above stand. Place the top of the stand
into the 5/8th (16mm) receiver mount, located
on the base of the yoke. Hold the light securely
with one hand, and use the other to twist the
mount’s locking knob clockwise until tight.
The C-Series fixture is secured inside of the
Photo Yoke using a Profoto© style mounting
ring around the outer diameter of the C-Series
fixture. Once the desired position of the
C-Series fixture is achieved, secure the ring in
place by closing the locking clamp attached
to the rubber collar on the outside of the
mounting ring.
the receiver tab on the accessory so that the
pull pin can drop down into the through hole
on the receiver tab. It is properly mounted and
immovable when the pin has fully descended
into the hole.
NOTE: Please visit www.hivelighting.com to learn more information about all of the
C-Series’ different power accessories and mounting options.