User Manual

C-SERIES ACCESSORIES / OPTICSHIVE LIGHTING19 20
ADDITIONAL OPTICS:
the front of the fixture, carefully slide the
mounting ring over the body of the light. Each
light modifier can be positioned differently
to create the optimal desired lighting effect.
Once the desired position of the light modifier
to the domed diffuser is achieved, secure the
ring in place by closing the locking clamp
attached to the rubber collar on the outside of
the mounting ring.
Lenses
Separately purchased lens kits include 3
interchangeable HDP Lenses: Medium, Wide
and Super Wide. To affix these to the device,
follow these steps: Rotate the top clip until
it is parallel to the reflector face. Slide
the desired lens into the reflector cage’s
inner lens stage, or slot (pictured on Page
16). Rotate the top clip back into its locked
position. Rotate lenses with elliptical beams
in order to position light projection in desired
location.
Barndoors
The barndoors can allow for greater control
in shaping the light. To attach: Rotate the top
clip until it is parallel to the reflector face
Slide the barndoors into the reflector cage’s
outer lens stage, or slot. Rotate the top
clip back into its locked position. Adjust one
or more of the leaves (i.e. “doors”) of the
barndoors to cut or shape the beam of light
emitted by a C-Series Light™.