User's Manual
Table Of Contents
- About This User’s Guide
- Table of Contents
- List of Figures
- List of Tables
- Introduction
- Cable
- 2.1 Cable Overview
- 2.2 The System Info Screen
- 2.3 The Initialization Screen
- 2.4 The Status Screen
- 2.5 The Password Screen
- LAN
- Firewall
- Parental Control
- Wireless
- EMTA
- Troubleshooting
- Index
22
HIT RON CVE-303 60 USER’ S GUIDE
INT RODUCT ION
If your CVE-30360’s DHCP server is active, select Get an IP address
automatically.
If your CVE-30360’s DHCP server is not active, select Use the following IP
address. In the IP address field, enter a value between 192.168.0.2 and
192.168.0.254 (default). In the Subnet mask field, enter 255.255.255.0
(default).
NOTE: If your CVE-30360 is not using the default IP address, enter an IP address
and subnet mask that places your computer in the same subnet as the CVE-
30360.
6 Click OK. The Internet Protocol (TCP/IP) window closes. In the Local Area
Connection Properties window, click OK.
Your computer now obtains an IP address from the CVE-30360, or uses the IP
address that you specified, and can communicate with the CVE-30360.
1. 5 LOGGING INTO THE CVE-30360
Take the following steps to log into the CVE-30360’s GUI.
NOTE: You can log into the CVE-30360’s GUI via the wireless interface. However, it
is strongly recommended that you configure the CVE-30360 via a wired
connection on the LAN.
1 Open a browser window.
2 Enter the CVE-30360’s IP address (default 192.168.0.1) in the URL bar. The
Login screen displays.
FIGURE 4: Login
3
Enter the Username and Password. The default login username is admin, and
the default password is password.