User Manual 1. How to Install Hardware A. Use a socket spanner screw off the cap (nearby the USB socket, back of the Hiteboard, circled by red line in the picture below), then fasten the steel bracket with wireless module by this screw cap. B. Connect Hiteboard and wireless module by USB cable, and power up the wireless module.
. Hiteboard Settings A. For QWB56, QWB200, QWB300 and QWB100WS, you should switch Hiteboard to COM port mode first. B. For QWB200frame, you should switch main board to TTL position first. C. This wireless module can not support QWB200slim. 3. Driver Install A. Put Wireless Module Driver CD into the computer B. Plug Dongle to USB port, Windows will show the ‘Found New Hardware Wizard’, choose “No, not this time” and click ‘Next’. Please see the picture below.
Please location to your CD-ROM driver, the Windows will install driver automatically. C. If there is a ‘Hardware Installation’ window (see the picture below), please click ‘Continue Anyway’. D. Once install finished, you can run the DigitalPenServer to start using Hiteboard. 4. Search Hiteboard A. Double click DigitalPenServer tray icon, then click ‘FindModule’. Wait for a few seconds the ‘Find module’ window will change to like this Click ‘Module list’, searched modules will show in the list.
5. Bind Dongle with Hiteboard If bind is successful, there should be a message box showing ‘Bind OK’, then click ‘OK’ to start connect to Hiteboard, it will take about 10 seconds to connect. After connect success, the using is same as connect by USB cable.
6. Notes A. Before searching wireless module, please make sure wireless module is power on. If searching failed, please click ‘Cancel’ and try it again. If still can not find any wireless module, please reset wireless module or reduce the distance between dongle and wireless module. B. While using wireless module, please make sure the distance between dongle and wireless module is less than 20m. 7. FCC Statement NOTE 1: This device complies with Part 15 of the FCC Rules.