Operation Manual

Motor

Electronic Speed

Control

Main Power Pack

Steering

Servo

■ ■

■

Connection with ElectrConnection with Electr

Connection with Electr

onic Speed Contronic Speed Contr

onic Speed Contr

olol

Electronic Speed Controls such as the Hitec HFX have a built in B.E.C. system inside the

speed control circuit. (Please verify whether your ESC has a built in B.E.C. circuit.) Plug

the receiver connector from the speed control into the “THROTTLE” or #2 channel on the

receiver, and the steering servo into the “STEERING” or #1 channel on the receiver. Now

you can connect the main power to the speed control and when the power switch is turned

on the speed control will regulate the power that the receivers can use.

3.T3.T

3.T

ansmitteransmitter

ansmitter

Recei Recei

Recei

er and Serer and Ser

er and Ser

o Settingso Settings

o Settings

Now we come to the critical part, as proper installation of these three main components

is essential.

■ ■

■

ChecChec

Chec

king operking oper

king oper

tion of the sertion of the ser

tion of the ser

✷ After the installing of the servo and receiver into your model, turn the transmitter

power “ON” and fully extend the antenna, now turn on the receiver. (It is advisable to

remove the pinion gear from your car so that the wheels do not engage for this test).

✷ Check to see if either servos or speed control are working properly. If not check the

connections and make sure the main battery pack is charged.