Owner's manual

7 Channel 2.4 GHz Aircraft Computer Radio System

Section 5: Acro and Glider Programming Menu

Flap Control

7. Scroll to highlight the “R/D” (right/down) eld and press the

jog dial to activate the menu.

8. Rotate the jog dial to increase (clockwise) or decrease

(counter-clockwise) the desired servo endpoint for when

the ap is fully deployed.

9. If the model has a second ap servo, repeat steps 4-8 on the

“FLP2” row of the value table.

10. Press the back button to return to the ap control menu.

11. Scroll to highlight the “ELEV” eld and press the jog dial to

activate the menu.

Be sure to have the elevator servo(s) congured properly before performing the next step.

Note

TipTip

Tip

Caution

12. Rotate the jog dial to input the desired amount of elevator throw when the aps are fully deployed.

Press the jog dial to conrm your input. Most models require down elevator with ap deployment,

which equates to positive values in this menu.

13. Scroll to highlight the “SPEED” eld and press the jog dial to

activate the menu.

14. Scroll to dene the amount of time (0.0 to 10.0 seconds) for

the aps and elevator mix to fully deploy. Press the jog dial

to conrm your selection.

15. Press the back button to return to the model function menu.

To disable ap control:

1. Scroll to highlight the “MIX” eld in the ap control menu and

press the jog dial to activate the menu. 2. Select “INH” (inhibit)

and press the jog dial to conrm your selection. Goes with

above screen shot.

3. Press the back button to return to the model function menu.

Offset

The Oset feature provides a convenient method to ne tune the neutral positions of the aileron, ap,

and elevator servo.

To congure oset:

1. From the model menu, rotate the jog dial to highlight “Oset”

and press the jog dial once to enter the activation menu.