Owner's manual
7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
68
Elevator to Camber Mixing cont.
22. Press the back button to return to the model function menu.
To disable the elevator-to-camber mix:
1. Scroll to highlight the “MIX” eld in the elevator-camber mix
menu and press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to conrm your
selection.
3. Press the back button to return to the model function menu.
To congure the camber mix:
1. From the Model menu, rotate the jog dial to highlight “Camber
Mix” and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the
jog dial to conrm your selection and activate the camber mix
menu.
4. Scroll to highlight the “AILE” eld and press the jog dial to
activate the menu.
Camber Mixing (GLID Only)
The Camber Mix feature allows you to dene the camber of the wing airfoil by raising or lowering the
wing control surfaces in unison. You may also adjust the elevator neutral position in each setting to
maintain proper pitch trim.
5. Rotate the jog dial to input the desired travel for the “AILE”
servo when camber is active. Press the jog dial to conrm
your input.
6. If the model has a second aileron servo, repeat step 5 in the
“AIL2” eld.
7. Scroll to highlight the “ELEV” eld and press the jog dial to
activate the menu.
8. Rotate the jog dial to input the desired travel for the “ELEV”
servo when camber is active. Press the jog dial to conrm
your input.
9. If the model has a second elevator servo, repeat step 8 in the
“ELE2” eld.