Owner's manual

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
67
Elevator to Camber Mixing cont.
18. Scroll to select “FLAP” and press the jog dial to conrm your
selection.
19. Repeat steps 5-15 to congure the ap movements for this
mix. If using only one ap servo, congure only the “FLAP”
row of the value table. If using two ap servos, congure
both rows of the value table.
20. Scroll to the “S/W” eld and press the jog dial twice to
activate the menu.
21. Scroll to select a switch to activate the mix. Press the jog dial
to conrm your selection.
a. If you choose the “NULL” option, the mix will remain active at
all times for this model.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight the
switch position that you will use to enable the mix. Press the
jog dial to conrm your selection
You may also select a ight condition in this menu by activating the desired ight condition.
Note
TipTip
Tip
Caution
c. If you choose “Cond” (Flight Condition):
-The upper right eld of the menu displays which ight
condition is currently active and will be programmed.
- Scroll to select “ON” and press the jog dial to conrm your
selection. If you toggle the selected switch, the eld in the
top right corner of the screen will indicate when the mix is
active.
- Scroll to the Flight Condition eld and press the jog dial to
activate the menu.
- Choose the desired ight condition and press the jog dial to
conrm your selection.
- Repeat steps 4-18 to dene the settings for each ight condition.