Owner's manual

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
61
V-Tail Mixing cont.
5. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a pitch
down command is given. Press the jog dial to conrm your
input.
3. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “ELEV receiver slot. This value regards the
servo travel when a pitch up command is given. Press the jog
dial to conrm your input.
9. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “RUDD” receiver slot. This value regards the
servo travel when a pitch up command is given. Press the jog
dial to conrm your input.
7. Press the back button to return to the V-tail menu.
8. Scroll to the top “RUDD” eld and press the jog dial to activate
the menu.
11. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a
pitch down command is given. Press the jog dial to conrm
your input.
13. Press the back button the return to the V-tail Mix menu.
14. Repeat steps 2-13 using the lower “ELEV and “RUDD” elds to set servo endpoints when yaw (rudder)
commands are given.
15. If elevator and/or rudder functions operate in the incorrect
direction, highlight the direction eld (“nor”) under the
reversed function and press the jog dial to activate the menu.
16. Scroll to select “rev” and press the jog dial to conrm your
selection. Verify that the control surfaces now move in the
correct direction.
17. Push the back button twice to return to the model function menu.