Owner's manual

7 Channel 2.4 GHz Aircraft Computer Radio System

Section 5: Acro and Glider Programming Menu

Aileron Differentials cont.

4. Scroll to the “S/W” eld and press the jog dial to activate the

menu.

5. Scroll to select a switch to control aileron dierential settings.

Press the jog dial to conrm your selection. If you choose the

“NULL” option, the current settings will remain active at all

times for this model. If you choose a switch, repeat steps 2-4 to

dene the settings for each switch position.

You can customize individual travel values in the “AILE” and “AIL2” elds by scrolling to those

elds and activating the sub-menus.

Note

TipTip

Tip

6. Press the back button to return to the model function menu.

Elevon Mixing

Flying wing aircraft are most often set up using elevon control surfaces. The Flash 7 mixes the aileron and

elevator functions to provide this conguration with just one ight control surface per wing panel.

It is not necessary to access or change this menu to y an elevon-equipped aircraft. The default

values are 100% in all directions.

Note

TipTip

Tip

Caution

1. From the model menu, rotate the jog dial to highlight “Elevon

Mix” and press the jog dial once to enter the elevon mix menu.

2. Scroll to the top “AILE” eld and press the jog dial to activate

the menu.

3. Scroll to highlight the “L/U” (left/up) eld and press the jog dial

to activate the menu.

4. Rotate the jog dial to increase (clockwise) or decrease

(counter-clockwise) the desired endpoint for the servo

attached to the “AILE” receiver slot. This value regards the servo

travel when a left roll command is given. Press the jog dial to

conrm your input.

5. Scroll to highlight the “R/D” (right/down) eld and press the

jog dial to activate the menu.

6. Rotate the jog dial to increase (clockwise) or decrease

(counter-clockwise) the desired servo endpoint when a right

roll command is given. Press the jog dial to conrm your input.