Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

DXXX Series Programming

Introduction

NOTE – If you always want the DPC-11 software

to launch in D-Series Mode you can change the start

window setting in the upper left hand corner of the

window.

WARNING

The DPC-11 Programming Software gives

the user unparalleled ability to adjust the

parameters of the Hitec DXXX series of Digital

Programmable Servos. Additionally users can

test their servos, save parameters to a file, load

parameters from a file and restore the factory

settings. To program your D Series servo, launch

the DPC-11 software from the desktop icon and

select D-Series from the startup menu.

User Interface The main screen of the D series programming

interface is broken into four sections,

Connection, File Operations, Testing and

Programming.

Change what window is shown when

launching program.

Connects or reconnects servo.

Takes you back to the main menu.

File operation section.

Testing section.

Programming section.

Section 3

DXXX Series Programming