Instructions

34
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Now you will setup the left and right end points.
When you have reached the desired end point click
either the “LEFT” or “RIGHT” button to confirm your
setting. You will be notified when each one is set.
7. Resetting EPAs
To reset your EPAs to the factory defaults, click
on the “Setting” box under the EPA programming
section then click EPA Reset. A message will appear
indicating the reset was successful.
Now you will setup the left and right end points.
CAUTION – Program the Fail Safe
point after setting the center and end
points, otherwise it will change when you
make those settings.
WARNING
WARNING
To set the Fail Safe point, first click on the “Setting”
box under the EPA programming use the arrows or
sliders to move the servo into the position you want
the servo to hold. Click on the “FS_position” button to
set the position.
Once complete, click the OK button to exit the EPA
setup.
8. Fail Safe Position
By choosing to use the Fail Safe function you will need
to set a preprogrammed travel point that the servo
will travel to in the event the servo loses signal from
the receiver.
HS-7XXX/5XXX Series Programming cont.