Instructions

32
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
2. Resolution (HS-7XXX series)
This feature allows a choice of high or normal
resolution for HITEC HS-7XXX Series digital servos.
In “High Resolution Mode”, the servo travels within a
120 degree angle, which allows the servo to move
in smaller “steps”, or at a “finer” level of resolution
for extraordinary precision applications. In “Normal
Resolution Mode”, the servo travel is a wider 180
degree angle, resulting in larger range of motion
delivering coarser “steps”. This allows a wider range
of travel, but at the cost of the very fine resolution
provided by the high resolution mode.
3. Travel Speed
This feature is useful for users who do not have
servo speed control functions on their transmitter.
Reducing the travel speed is a nice feature to slow
down aircraft landing gear retracts. The servo speed
function will only slow a servo down, you cannot make
a servo travel faster than its rated speed. You can
adjust the servos travel speed in ten proportional
steps from a minimum speed (10%) up to its
maximum speed (100%).
This feature is useful for users who do not have
4. Dead Band Width
Some applications, such as using multiple servos on
a single control surface, may require you to change
the center “Dead Band” to prevent the servos from
fighting each other. Users can adjust the center
point “Dead Band Width” to one of five choices with 1
being the most sensitive and 5 the least sensitive.
HS-7XXX/5XXX Series Programming cont.