Instructions

30
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Manual Position Test
Click on the pre-set buttons or move the slide
bar with your mouse to manually move your
servos position.
End Point Adjusters
Click for Fine Movements
Slide for Bigger Movements
Preset Positions
Auto Sweep Positioning Test
Using the DPC-11 HS-5XXX/7XXX
Series Test Functions:
The “Auto-Sweep” function will cycle a servo over
and over from end point to end point.
1. Select Sweep on the menu and click the
START button. The servo will then move from
end point to end point within its travel limits.
2. Use the slide bar next to the START/STOP
button to adjust the servo’s travel speed.
3. Click STOP to end the process.
Automatic Step Positioning Test 1. Select Step and click the START button. Your
servo will start moving from end point to end
point in a series of small “steps”.
2. Use the slide bar next to START/STOP
buttons to adjust the servo’s travel speed.
3. Click STOP to end the process.
HS-7XXX/5XXX Series Programming cont.