Instructions

27
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
2. Load a File
To load a parameter file, click on “OPEN”, navigate to
the location you have stored your file, and click on the
file name you want to open. You will get the “File load
has completed” prompt. Click “OK.” Now click “Write
All” to load the setting into the servo. Once you see
the “Write All completed” message, click “OK.” The
parameters have been written to the servo.
3. Restoring Factory Defaults
To restore the servo to the factory default setting,
click on “OPEN” and navigate to the directory in which
you unzipped the DPC-11 software download. In the
directory, “Factory Defaults,” you will find the files
for each servo model. Click on the file that matches
the servo you want to restore and click on “Open.”
Once you see the file load has completed message,
click OK. Now click “Write All” to load the setting into
the servo. Once you get the “Write all completed”
message, click “OK.” The default parameters have
been written to the servo.
CAUTION – Restoring a factory default file other
than the one specifically made for your servo model
may result in undesired operation.
WARNING
WARNING
HSB-9XXX Servo Programming cont.