Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

5. Center & End Point Setting (EPA)

With the EPA setup, users can customize the center

point and left/right servo travel end points. This can

be helpful to fine tune your model’s control surfaces.

To set the Center and Endpoints, click on the

“Setting” box under the EPA programming section.

6. Resetting EPAs

To set or reset your EPAs to the factory

defaults, click on the “Setting” box under the EPA

programming section. Then click EPA Reset.

NOTE – You can slide the adjustment bar to move

in larger steps. You can click the arrows “< >” on

each end to make single point adjustments, or you

can click on the white space of the adjustment bar to

move it in 10 point increments.

WARNING

The first setting is the center point, click “OK” to

continue. You can adjust the center point using three

different methods.

When you have reached your desired center point,

press okay to continue. You will now be prompted to

setup the Left and Right End Points. To setup the left

and right end points, click “OK” when prompted by

the pop-up screens. Just like with the center point,

you can adjust them in the same manner with the

only exception being that clicking on the white space

of the adjustment bar moves it in increments of 5

points.

HSB-9XXX Servo Programming cont.