Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

2. Travel Speed

This feature is useful for users who do not have

servo speed control functions on their transmitter.

Reducing the travel speed is a nice feature to slow

down aircraft landing gear retracts. The servo

speed function will only slow a servo down. You

cannot make a servo travel faster than its rated

speed. You can adjust the servo’s travel speed in ten

proportional steps from a minimum speed (10%) up

to its maximum speed (100%).

3. Dead Band Width

Some applications, such as using multiple servos on

a single control surface, may require you to change

the center “Dead Band” to prevent the servos from

fighting each other. Users can adjust the center

point “Dead Band Width” to one of five choices, with

1 being the most sensitive and 5 the least sensitive.

4. Soft Start Setting

The soft start setting allows users to set how fast

the servos react when first powered on. Using a

slower soft start setting can prevent damage to

your model by slowly moving the servo into position.

Default Setting is 20% (slowest). There are five

setting from 20% to 100%, which is instantaneous

reaction.

NOTE – This setting has no effect on

the reaction speed of the servo once it is

powered up.

WARNING

HSB-9XXX Servo Programming cont.