Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

NOTE – The FAIL SAFE point must be set by the

user in the programming section under. Setting the

FAIL SAFE Point.

WARNING

FAIL SAFE Test

Programming your Hitec Brushless

Servos:

NOTE – To make your changes

permanent you must “write” the

programming to the servo by clicking the

WRITE ALL button. You can do this after

each programming step or wait until you

have finished all programming.

WARNING

This feature tests the user-programmed FAIL

SAFE point of your servo.

If not already, turn on the Fail Safe by clicking

the “Fail_Safe” button under “Program” and click

“FS_Start.” The servo will travel to its preset Fail

Safe position.

The following functions can be programmed into

the HITEC BLDC servos using the DPC-11. It is

recommended that you program your servos in

the following order:

1. Direction of Rotation

2. Travel Speed (Slower)

3. Dead Band Width

4. Soft Start Percentage

5. Center and End Points

6. FAIL SAFE, On or Off

1. Direction of Rotation

Normal servo rotation based on 900 - 2100µs input

signal is clockwise from left to right. You can change

this to counterclockwise by clicking on the direction

of travel button as shown. The direction is shown as

CW for clockwise and CCW for counterclockwise.

HSB-9XXX Servo Programming cont.