Instructions

21
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Manual Position Test
Click on the pre-set buttons or move the slide
bar with your mouse to manually move the
position of your servos.
End Point Adjusters
Click for Fine Movements
Slide for Bigger Movements
Preset Positions
Auto Sweep Positioning Test
Using the DPC-11 HSB-9XXX Series
Test Functions:
The “Auto-Sweep” function will cycle a servo over
and over from end point to end point.
1. Select “Sweep” on the menu and click the
“START” button. The servo will then move from
end point to end point within its travel limits.
2. Use the slide bar next to the “START/STOP”
buttons to adjust the servo’s travel speed.
3. Click “STOP” to end the process.
Automatic Step Positioning Test 1. Select “Step” and click the START button.
Your servo will start moving from end point to
end point in a series of small “steps.”
2. Use the slide bar next to the START/STOP
button to adjust the servo’s travel speed.
3. Click STOP to end the process.
NOTE – You can use the Endpoint
Slide Bars to set the end points for both
auto sweep and auto step functions as
described below.
WARNING
WARNING
HSB-9XXX Servo Programming cont.