Instructions

2
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
WARNING – Failure to follow these instructions
can result in an undesired operation of your servo.
Please read these instructions before attempting to
program your servos.
WARNING
WARNING
Section 1
Congratulations on your purchase of the DPC-
11 Universal Programming Interface for Hitec
programmable servos. The DPC-11 allows you to
customize the parameters of our programmable
DXXX, HSB-9XXX, HS-7XXX and HS-5XXX series
servos to better suit your application. Additionally, you
can test your settings to make sure you achieve the
desired results before installing the servos in your
aircraft or vehicle.
Introduction
Package Contents
- DPC-11 PC Programming Interface
- This manual
Additional Items Needed for Usage
- USB 2.0 Compliant Cable Type A to Mini B
- 4.8 – 7.4v Battery
- PC running Microsoft Windows ® [XP, 7, 8 or 10]
Function Status
End Point Adjustments
Direction
Fail Safe
Dead Band
Speed (Slower)
Soft Start Rate
Overload Protection
Resolution
Data Save/Load
Program Reset
HS-5XXX/7XXXHSB-9XXX/7XXXD Series
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
From File
X
X
X
X
X
X
X
X
X
Programmable Features
The chart below indicates what you can program in each servo series.
WARNING – DO NOT attach the DPC-11 until all
software installation steps are completed for your
operating system.
WARNING
WARNING
1. Download the DPC-11 software from
www.hitecrcd.com.
2. Follow the instructions included with the download
and install the DPC-11 software.
Basic Set-Up Instruction
Introduction