Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

Next move your servo to the desired position by

using the Manual positioning section as shown.

Once you have your desired Fail Safe position, click on

the “FS-Position” button Fail Safe Test as seen in the

illustration.

OLP is a “protection against servo damage” feature.

When a servo is at “full stall torque” and the servo

power amplifier is sending the maximum power to

the servo motor, the OLP circuit will engage and

reduce the power being sent to the motor. This

act of power reduction could help prevent a critical

failure of one or more servo components. When

the servo is fully stalled, the OLP circuit will reduce

the power from the servo amp to the servo, by the

percentage selected. Selecting a value of 20%, will

reduce the power sent to the motor by 20%. This

effectively reduces the servo power to 80% of its

potential. The factory default setting is always “OFF.”

9. Overload Protection (OLP)

DXXX Series Programming cont.