Instructions

16
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Now you will setup the left and right end points.
When you have reached the desired end point, click
either the “LEFT” or “RIGHT” button to confirm your
setting. You will be notified when each one is set.
Once complete, click the OK button to exit the EPA
setup.
7. Resetting EPAs
To set or reset your EPAs to the factory
defaults, click on the “Setting” box under the EPA
programming section then click on “EPA_Reset.”
By choosing to use the Fail Safe function you will need
to set a preprogrammed travel point that the servo
will travel to in the event the servo loses signal from
the receiver.
8. Fail Safe Position
CAUTION – Program the Fail Safe
point after setting the center and end
points, otherwise it will change when you
make those settings.
WARNING
WARNING
To set the Fail Safe point, first click “Fail Safe” under
the Program section.
DXXX Series Programming cont.