Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

5. Soft Start Setting

The soft start setting allows users to set how fast

the servos react when first powered on. Using a

slower soft start setting can prevent damage to

your model by slowly moving the servo into position.

Default setting is 20% (slowest). There are five settings

from 20% to 100% which is instantaneous reaction.

NOTE – This setting has no effect on

the reaction speed of the servo once it is

powered up.

WARNING

6. Center & End Point Setting (EPA)

With the EPA setup, users can customize the center

point and left/right servo travel end points. This can be

helpful to fine tune your model’s control surfaces. To

set the Center and Endpoints, click on the “Setting” box

under the EPA programming section to enter the EPA

programming Section.

NOTE – You can adjust the EPA setting

by moving the slide in the adjustment bar

to make larger adjustments. Click the

arrows “< >” on each end to make single

point adjustments, or you can click on

the white space of the adjustment bar to

move it in 50 point increments.

WARNING

The first setting is the center point. When you have

reached your desired center point, click on “CENTER”

to set this point and continue on to the left and right

endpoints. Click “OK” when prompted by the pop-up

screen.

DXXX Series Programming cont.