Instructions

14
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
2. Direction of Rotation
Normal servo rotation based on 900 - 2100µs input
signal is clockwise from left to right. You can change
this to counterclockwise by clicking on the Direction
of travel button as shown. The direction is shown as
CW for clockwise and CCW for counterclockwise.
3. Travel Speed
This feature is useful for users who do not have
servo speed control functions on their transmitter.
Reducing the travel speed is a nice feature to slow
down aircraft landing gear retracts. The servo speed
function will only slow a servo down, you cannot make
a servo travel faster than its rated speed. You can
adjust the servos travel speed in ten proportional
steps from a minimum speed (10%) up to its
maximum speed (100%).
4. Dead Band Width
Some applications, such as using multiple servos on
a single control surface, may require you to change
the center “Dead Band” to prevent the servos from
fighting each other. Users can adjust the center
point “Dead Band Width” to one of five choices with 1
being the most sensitive and 5 the least sensitive.
DXXX Series Programming cont.