Instructions

13
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Programming Your Hitec D Series
Servos
The following functions can be programmed into
the HITEC D Series servos using the DPC-11.
It is recommended that you program your
servos in the following order:
1. ID Setting
2. Direction of Rotation
3. Travel Speed (Slower)
4. Dead Band Width
5. Soft Start Percentage
6. Center and End Points
7. FAIL SAFE, On or Off
8. Overload Protection (OLP)
1. ID Setting
With ID Setting you can number your servos with a
specific ID anywhere from 0-255. This can be helpful
when programming new servos or for use when
saving the parameters to a file.
DXXX Series Programming cont.