Instructions

DPC-11

UNIVERSAL PROGRAMMING INTERFACE

FOR HITEC PrOGRAMMABLE SERVOS

Automatic Step Positioning Test 1. Select Step and click the START button. Your

servo will start moving from end point to end

point in a series of small “steps”.

2. Use the slide bar next to START/STOP

buttons to adjust the servo’s travel speed.

3. Click STOP to end the process.

FAIL SAFE Test This feature tests the user programmed FAIL

SAFE point of your servo.

NOTE – The FAIL SAFE point must be set by the

user in the programming section under setting the

FAIL SAFE Point.

WARNING

By clicking the FS-Position button, the servo will

travel to its preset Fail Safe position.

DXXX Series Programming cont.