Instructions

11
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Manual Position Test
Now click the “Connect” button in the DPC-11
software. If your connections are correct, your
screen will look something like this;
Click on the pre-set buttons or move the slide
bar with your mouse to manually move your
servo’s position.
End Point Adjusters
Click for Fine Movements
Slide for Bigger Movements
Preset Positions
NOTE – You can use the Endpoint Slide Bars bar
to set the end points for both auto sweep and auto
step functions as described below
WARNING
WARNING
Auto Sweep Positioning Test
Using the DPC-11 D-XXX Series
Test Functions:
The “Auto-Sweep” function will cycle a servo over
and over from end point to end point.
1. Select Sweep on the menu and click the
START button. The servo will then move from
end point to end point within its travel limits.
2. Use the slide bar next to the START/STOP
button to adjust the servo’s travel speed.
3. Click STOP to end the process.
DXXX Series Programming cont.