Instructions

10
DPC-11
UNIVERSAL PROGRAMMING INTERFACE
FOR HITEC PrOGRAMMABLE SERVOS
Test Functions Testing a servo’s function can be critical to
completing a successful project. Use these tests
to “burn-in” new servos or to check for broken
gears and other issues. The DPC-11 is capable
of performing the following tests:
1. Servo Travel using one of the following methods:
a. Manual Positioning
b. Automatic Sweep Positioning
c. Step Positioning
2. FAIL SAFE programming position
Programming Functions The following functions can be programmed into
the D Series servos using the DPC-11:
1. FAIL SAFE, On or Off.
2. Direction of Rotation
3. Servo ID Number
4.Travel Speed (Slower)
5. Center, End, and FAIL SAFE Point
6. Dead Band Width.
7. Soft Start
8. Overload Protection
File Operations In the File Operations section you can perform
the following tasks;
1. Save a servo’s parameters to a file
2. Load a servo’s parameters from a file
3. Write the programmed information to the servo
4. Reset the servo to factory defaults
Connecting Your Servo It is recommended that you connect your DPC-11
in the following order for proper operation:
1. Connect DPC-11 to your PC computer
2. Launch the DPC-11 software
3. Connect your servo to the servo port
4. Connect a battery or other power source to
the battery port
DXXX Series Programming cont.