Data Sheet

1716
PROGRAM SELECT(01)
Mode: Discharge
C.Current OFF
D. Current -2.0A
Operating the Charger (continued)
C. Current (Charge Current)
The charger supports a maximum 6.0A
charge current, but a current suitable for your
battery should be set. It is inappropriate to
set a high charge current for a low capacity
battery, as doing so would result in unwanted
consequences.
*NOTE: This mode is only available under the
Charge mode
D. Current (Discharge Current)
The charger supports a maximum -2.0A dis-
charge current, but users should set the appro-
priate discharge current for the battery in use.
* Note that this mode is only available under the
Discharge mode.
Target Volt - (Target Voltage)
This function is available when working with-
Lithium and Lead Acid (Pb) chemistry batteries.
Here you can set the target voltage for each
individual cell.
WARNING: Setting the target voltage too high
can damage your battery and cause your bat-
tery to explode. See the packs manufacturer’s
recommended settings before changing this
value from the defaults.
Cut Volt - (Cutt-o Voltage)
This function can be activated under Discharge
mode no matter the type of batteries being
discharged. This function protects a battery
from deep discharging. Refer to the chart on
page 6 for recommended cut-o voltage.
PROGRAM SELECT(01)
Cycle Count:
Repeak Count: OFF
Trickle: OFF
Cut Volt: OFF
OFF
Cycle Mode
In Cycle Mode, users can choose
between charging>discharging or
discharging>charging. There are two
requirements for making the Cycle Mode
accessible: 1. the battery type must be NiMH
or NiCd and 2. the mode must be Cycle. This
mode is intended to help refresh your battery
if it has been sitting for a long period of time.
Cycle Count
In cycle mode, users must select the number of
cycles (between 1 and 5) for the Cycle Count.
Repeak Count
There are two requirements for accessing
Repeak Count: 1. the battery is either NiMH
or NiCd and 2. users are in Re-Peak mode.
There are 3 Repeak Counts in total.
Trickle
When the Trickle function is activated, the
battery will continue charging, but at very
low current. This function is only available
when charging a NiMH or NiCd battery.
PROGRAM SELECT(01)
Cycle Count:
Repeak Count: OFF
Trickle: OFF
Cut Volt: OFF
O
Operating the Charger (continued)
The following functions are available when working with NiMH or NiCd bat-
teries
PROGRAM SELECT(01)
Battery Cells: 5S
Mode: Cycle
C.Current 3.0A
D. Current -1.0A
PROGRAM SELECT(01)
Cycle Count:
Repeak Count: OFF
Trickle: OFF
Cut Volt: OFF
4
PROGRAM SELECT(01)
C. Current 3.3A
D. Current OFF
Target Volt: 4.20V
Cut Volt: OFF
PROGRAM SELECT(01)
Battery Type: LiPo
Battery Cells: 3S
Mode: Balance
C. Current 3.3A
Battery Cells: 3S
PROGRAM SELECT(01)
C. Current 3.3A
D. Current OFF
Target Volt: 4.20V
Cut Volt: OFF