User manual

- 19 -
DISCHARGING OF LITHIUM BATTERY
DISCHARGING OF LITHIUM BATTERY
The setting of the discharge current on the
left cannot exceed 1C, and the setting on
the right cannot be under the voltage
recommended by the manufacturer to avoid
deep discharging. Press the START/ENTER
key for more than 3 seconds to start
discharging.
LiPo DISCHARGE
1.0A 11.1V(3S)
INC
INC
DEC
-+
INCDEC
-+
Batt type
Stop
Start
Enter
‘>3 seconds’
This shows the real-time status of discharging;
you can press the BATT TYPE/STOP key to
stop discharging.
Li3s 0.4A 12.59V
DSC 022:43 00682
BATTERY VOL ERR
CELL LOW VOL
4.14 4.16 4.09
2.18 0.00 0.00
Number
of cells
Elapsed
time
Discharge
current
Battery
voltage
Discharged
capacity
The processor monitors the voltage of each cell when the battery packs
are in the “storage” and “discharging” process. If the voltage of any cell
is abnormal, the X1 will show an error message and forcibly terminate
the program. So if there is battery damage or a disconnection, you can
see the error message and press INC to know which cell is damaged.
VOLTAGE BALANCING AND MONITORING IN THE
DISCHARGE PROCESS
This screen shows that the processor
detects that the voltage of one cell is
too low.
This screen shows the 4th cell was damaged.
If disconnection occurs, the setting of the
voltage may be zero.