User manual

- 17 -
FAST CHARGING OF LITHIUM BATTERY
LiPo FAST CHG
2.0A 11.1V(3S)
INCDEC
-+
INCDEC
-+
Batt type
Stop
Start
Enter
Start
Enter
‘>3 seconds’
R:3SER S:3SER
CONFIRM(ENTER)
Li3s 2.0A 12.59V
FAS 022:43 00682
Number
of cells
Charging
time
Charging
current
Current
voltage
battery
Supplied
capacity
In this mode, the charging current will lower toward the end of the
charge process. Toward the end of the charging process the constant
current (CV) will be reduced to 1/5 of the currant when the pack is
90% charged. The charging capacity will be slightly lower than normal
charging, but charging time will be reduced.
CHARGING LITHIUM BATTERY IN THE FAST CHARGE MODE
FAST CHARGING OF LITHIUM BATTERY
The left side of the first line shows the type of
battery chosen. The setting on the left of the
second line is the current set by the user. After
setting the current and voltage, press the
START/ENTER key for more than 3 seconds
to start the process
(charge current: 0.1-5.0A, voltage: 3.7-22.2V).
This displays the number of cells you set up
as ”R” and the processor detects as “S”. If
both numbers are identical, you can start
charging by pressing the START/ENTER
button. If not, press the BATT TYPE/STOP
button to go back to the previous screen to
carefully check the number of cells of the
battery pack before proceeding.
This screen shows the real-time status during
the charge process. Press the
BATT TYPE/STOP key once to stop the
charge process.