User manual

- 16 -
CHARGING LITHIUM BATTERY IN THE CHARGE MODE
CHARGING LITHIUM BATTERY IN THE CHARGE MODE
This charging mode is for charging Li-Po/Ion/Fe batteries without a
balance lead.
The left side of the first line shows the type of
battery chosen. The setting on the left of the
second line is the current set by the user. After
setting the current and voltage, press the
START/ENTER key for more than 3 seconds
to start the process
(charge current: 0.1-5.0A, voltage: 3.7-22.2V).
BALANCE CHARGING OF LITHIUM BATTERY
LiPo BALANCE
2.0A 11.1V(3S)
INCDEC
-+
INCDEC
-+
Batt type
Stop
Start
Enter
Start
Enter
‘>3 seconds’
This displays the number of cells you set up as
”R” and the processor detects as “S”. If both
numbers are identical, you can start charging
by pressing the START/ENTER button. If not,
press the BATT TYPE/STOP button to go back
to the previous screen to carefully check the
number of cells of the battery pack before
proceeding.
R:3SER S:3SER
CONFIRM(ENTER)
This screen shows the real-time status
during the charge process. Press the
BATT TYPE/STOP key once to stop the
charge process.
Li3s 1.2A 12.59V
BAL 022:43 00682
Number
of cells
Charging
time
Charging
current
Battery
voltage
Charged
capacity
This function is for balancing the voltage of Lithium-polymer battery cells
individually while charging. In the balance mode, the battery needs to
have a balance lead to connect to the balance port at the right side of
the charger and the battery's power leads to the output of the charger.
Charging in this mode is different from the normal modes because the
built-in processor monitors the voltage of each individual cell and controls
the input current fed into each cell in order to equalize the voltage.
CHARGING LITHIUM BATTERY IN THE BALANCE MODE