User manual

- 15 -
LITHIUM (LIPO/LILON/LIFE) PROGRAM
LITHIUM (LIPO/LILON/LIFE) PROGRAM
This program is only suitable for charging/discharging Lithium
(LiPo/LiIon/LiFe) batteries with a nominal voltage of 3.3/3.6/3.7V/cell.
The final voltage is very important; it should precisely match the
voltage of the battery: LiPo is 4.2V, LiIon is 4.1V and LiFe is 3.6V.
The current and voltage of the battery should be correctly set. When
you want to change the settings, please press the START/ENTER key
to make it blink and then use the DEC or INC to change the setting.
Then press the START/ENTER key again to store the setting.
The left side of the first line shows the type of
battery chosen. The setting on the left of the
second line is the current set by the user.
After setting the current and voltage, press
the START/ENTER key for more than 3
seconds to start the process
(charge current: 0.1-5.0A, voltage: 3.7-22.2V).
CHARGING LITHIUM BATTERY IN THE CHARGE MODE
LiPo CHARGE
2.0A 11.1V(3S)
INCDEC
-+
INCDEC
-+
Batt type
Stop
Start
Enter
Start
Enter
‘>3 seconds’
This displays the number of cells you set up
as ”S” and the processor detects as “R”. If
both numbers are identical, you can start
charging by pressing the START/ENTER
button. If not, press the BATT TYPE/STOP
button to go back to the previous screen to
carefully check the number of cells of the
battery pack before proceeding.
R:3SER S:3SER
CONFIRM(ENTER)
This screen shows the real-time status
during the charge process. Press the BATT
TYPE/STOP key once to stop the charge
process.
Li3s 1.2A 12.59V
CHG 022:43 00682
Number
of cells
Charging
time
Charging
current
Battery
voltage
Charged
capacity