User manual

- 13 -

INITIAL PARAMETER SETUP (USER’S SET-UP)

NIMH Sensitivity

D.Peak Default

NICD Sensitivity

D.Peak Default

Temp. Cut-off

ON 80C

INCDEC

recognizes the cell count incorrectly at the

beginning of the charge or discharge process,

you may extend the time. Otherwise, you should

use the default value.

This shows the cutoff voltage for the automatic

charge termination of a NiMH and NiCd battery.

The effective setting ranges from 5 to 20mV per

cell. If the trigger voltage is set higher, there is a

danger of overcharging the battery; if it is set

lower, there is a possibility of premature

termination. Please refer to the technical

specification of the battery.

(NiCd default: 12mV, NiMH default: 7mV)

The temperature cutoff will be turned on or off

with the use of the optional temperature probe

by contacting the surface of the battery. If it is

on, set the maximum temperature at which the

charger should allow the battery to reach during

charging. Once a battery reaches this

temperature, the process will be terminated to

protect the battery.

Waste time

CHG/DCHG 5min

The battery becomes warm after cycles of the

charge/discharge process. The program will

insert a time delay after each charge/discharge

process to allow the battery enough time to cool

down before beginning the next cycle of charge/

discharge. The setting ranges from 0 to 60 minutes