User manual

- 12 -
INITIAL PARAMETER SET-UP (USER’S)
INITIAL PARAMETER SET-UP (USER’S SET-UP)
As a default, this charger will be set to default user settings when it is
connected to AC 110-240V or DC 11-18V for the first time. The screen
displays the following information in sequence and the user can
change the parameters on each screen.
The X1 recognizes the cell count of the Lithium
battery automatically at the beginning of the charge
or discharge process to avoid an erroneous setting
by the user. To prevent a deeply discharged battery,
which can be perceived incorrectly, from causing an
error, you can set the timer to verify the cell count
by the processor. Normally, 10 minutes is enough
to perceive the cell count correctly. For a battery of
larger capacity, you may extend the time term.
However, if you set the it too long for a battery of
smaller capacity, the charge or discharge process
can be finished within the time term with an
erroneous cell count. This may cause a fatal result.
If the processor
USER SET
PROGRAM->
LiFe
V.Type 3.3V
LiPo/LiIo/LiFe
CHK Time 10min
INC
INCDEC
INCDEC
This is the set-up starting screen.
The screen displays the nominal voltage of a
Lithium battery. There are three kinds of Lithium
batteries: LiFe(3.3V), Lilo(3.6V) or LiPo(3.7V).
This is very important so you have to check the
battery carefully and set it up correctly. If it is
different from the correct setting, the battery
may explode during charge process.
If you need to alter the setting in the program, press the “Start/Enter”
key to make it blink then change the setting with the “INC” or “DEC”
key. The setting will be stored by pressing the “Start/Enter” key once.
-+