User manual

- 09 -
WARNING AND SAFETY NOTES
Have you checked that all connections are firm and secure?
Make sure there are no intermittent contacts at any point in the
circuit.
Charging
During the charging process, a specific quantity of electrical
energy is fed into the battery. The charge quantity is calculated
by multiplying charge current by charge time. The maximum
permissible charge current varies depending on the battery type
or its performance, and can be found in the information provided
by the battery manufacturer. Only batteries that are expressly
stated to be capable of quick-charge are allowed to be charged
at rates higher than the standard charge current.
Connect the battery to the terminal of the charger: red is positive
and black is negative. Due to the resistance difference between
the cable and the connector, the charger can not detect the
resistance of the battery pack. In order for the charger to work
properly, the charge leads should be of adequate cross-section
with high quality (normally gold-plated) connectors fitted to
both ends.
Always refer to the manual provided by the battery manufacturer
pertaining to charging methods, recommended charging current
and charging time. Lithium batteries, in particular,should be
charged strictly according to the charging instructions provided
by the manufacturer.
Special attention should be paid to the connection of the Lithium
battery.
Do not attempt to disassemble the battery pack arbitrarily.