User's Manual

CH1
CH2
BATT
Battery Eliminator Circuit
ZR-102SA
AM
4 5
SET-UP AND INSTALLATION OF YOUR ZEBRA 2AM
BATTERY INSTALLATION
5. Always return the battery cover first before turning on the transmitter power.
5. Please refer to the instructions manual in your electronic speed controller for proper installation.
Please read the following section carefully before attempting to install the Zebra 2 AM system
RADIO SYSTEM INSTALLATION
1. Install your receiver in the safe location to protect from vibration or potential crash damage.
2. Typically one servo will be used for the steering and the other servo will be used to operate a mechanical speed controller.
or an optional electronic speed control will be used.
3. If your vehicle is electronic powered type, there will be a proportional speed control you wish to use.
If your speed control is mechanical, it will require a servo to operate it.
The battery and switch harness found in the kit must also be used to provide the receiver with power.
4. If your model is using an electronic speed controller that has the option of the B.E.C.(battery eliminator circuit),
receiver batterys are not needed on this since motor battery will feed the receiver and servos through the speed control.
When installing radio system on your R/C car, please follow the instruction included in your R/C car.
BATTERY COVER
TO OPEN THE BATTERY COVER
OF THE ZEBRA 2 AM, YOU NEED TO
PRESS THIS AND PUSH IT DOWNWARD.
6 AA SIZE BATTERY MUST BE
LOADED IN CORRECT
POLARITY AS SHOWN
BLACK󰼿(-)󰼿󰼿󰼿󰼿󰼿󰼿󰼿
BATTERY󰼿
7.2V - 8.4V
RED󰼿(+)󰼿󰼿󰼿󰼿󰼿󰼿󰼿
STEERING󰼿SERVO
THROTTLE󰼿SERVO
YELLOW󰼿(+)󰼿󰼿󰼿󰼿󰼿󰼿󰼿󰼿
BLUE󰼿(-)󰼿󰼿󰼿󰼿󰼿󰼿󰼿
+
-
MOTOR󰼿󰼿󰼿󰼿󰼿󰼿󰼿󰼿󰼿󰼿
CAPACITOR󰼿󰼿󰼿󰼿
DUAL󰼿LED󰼿󰼿󰼿󰼿󰼿
RED󰼿:󰼿BRAKE󰼿󰼿󰼿󰼿󰼿󰼿
GREEN󰼿:󰼿FULL󰼿POWER
INDICATOR󰼿󰼿󰼿󰼿
SET󰼿UP󰼿BUTTON
On/Off󰼿Switch
ESC Installation
ESC
For ZEBRA 2 CHANNEL
RECEIVER
Normal Installation
CH2
CH1
CH2
BATT
1. You need to have 6 cells of AA size batteries for transmitter, and 4 cells for receiver.
(You can use Alkaline, Ni-cad or Ni-Mh cells according to your preference)
2. Always make sure the receiver and transmitter are off before loading the battery.
3. Open the battery cover on the back of the transmitter.
4. Load batteries appropriately into the slots. Please make sure to install the batteries with correct polarity as shown below.
WITH󰼿0.1 F󰼿
Zebra 2 AM Instruction ManualZebra 2 AM Instruction Manual
E S C
Zebra