User's Instructions

7
b. Steering servo trim setting
After verifying that the steering direction is correct, then set the steering trim knob to
the center if the servo horn or arm should be at 90 degrees and the wheels should be
straight. If not then make the horn or arm 90 degrees by removing it and replacing it
correctly. If the arm is at 90 degrees and the wheels are not straight adjust the linkage
to compensate. Once you’ve got these two setting correct the use the steering trim for
fine tuning. Note: (Always Trim your car before you run or race) This is a common
mistake made by beginners, if you have to steer your car to go straight, you are
fighting a loosing battle. Make sure it goes straight before you run and driving will
become much easier.
c. Throttle Servo Settings
- Using Mechanical Speed Control