User's Instructions

5
5. Transmitter, Receiver and servo settings
Now we come to the critical part as proper installation of these three main components is
essential.
a. Checking operation of the servo
* After installation of the servo and receiver into your model is complete, turn the power
“ON” the transmitter (fully extend the antenna) now turn on the receiver. (It is advisable
to remove the pinion gear from your car so that the wheels do not engage for this test)
* Check to see if both servos and/or speed control are working properly. If not check the
connections and/or make sure the main battery pack is charged.
* Check to see if the servos are moving in the correct direction. If not, change the servo
reversing switch located on the top of the transmitter to achieve the correct direction.
* If everything checks out then turn the receiver “OFF” first, then the transmitter
(Always remember Never have the receiver “ON” with out the transmitter being “ON” this
means when turning you model “ON” always turn the transmitter “ON” first and “OFF”
last)
Warning!!! : Do not shorten the length of the receiver antenna by cutting off any excess
wire this will severely affect the operating range and could result in injury to yourself and
others.