Intro. Thank you for purchasing the LYNX 4S transmitter. LYNX 4S is composed of diverse features to maximize customer’s R/C experiences. Please read carefully to become familiar with LYNX 4S under your control. After reading this, please keep this manual for easy reference. Product Specifications - Frequency Range : 2.4092GHz~2.474GHz - Modulation : Frequency Hopping Spread Spectrum (FHSS) - Tx Power : Max.
- 30 – Model Memory(Micro SD - Add 30 memory, Total 60 memory) - 12 letter model name - Easy Left-hander change Mode - PC link and Upgrade - Earphone connection - Extension Mountain Mode - Various Battery Compatibility(Lipo / Life / NiMH / NiCD) Transceiver Binding(ID setting) 1. Power ON_(Get off down SW_ Displayed in the upper right corner of the screen, you must have a RF.) 2. Dial SW press once(Go to the menu screen.) 3. Dial SW keep turning down the SYSTEM menu. 4.
1. RX-click the Link button on the power (4.8V) is applied to the link SW release. 2. RX intersection Blinks the LED on the end of the BLUE color. 3. The power OFF and then ON. 9. RX and press ESC SW BINDING is complete. 10. For about 5 seconds, then press ESC SW twice more, go to the main menu screen. (Warning – Available LINK range of Tx and Rx is between 45cm and 5M.
Fail safe and hold mode When Rx signal take effect on external influence if you set the Fail - safe mode, the servo will go to Fail–safe position you stored already. The servo will turn off the power for 1 second in hold time if you didn’t enable the Fail–safe mode. Then the servo will keep no-load condition and move to the position that is ordered last time until it detects a normal signal again.
(Warning – The Fail-safe setting will delete you set lastly if the Fail-safe mode is disabled. Always check the Fail-safe mode work normally before you turn on the engine or motor.) Low Battery Warning - The battery voltage is normal, there is no change in the module. - The battery voltage is low, the alarm sounds. Please check the battery voltage immediately if you here a beep in flight. Range Check Please check the range for verifying that transceiver operate normally.
WARNING & SAFETY INFORMATION Safety Symbols Warning 9JGP GPEQWPVGTKPI VJKU U[ODQN KP VJG OCPWCN [QW OWUV HQNNQY VJGUG 㿋 # FCC Information 6JKU FGXKEG EQORNKGU YKVJ RCTV QH VJG (%% 4WNGU 1RGTCVKQP KU UWDLGEV VQ VJG HQNNQYKPI VYQ EQPFKVKQPU TGEQOOGPFCVKQPU VQ CXQKF KTTGRCTCDNG FCOCIG VQ [QWT ECT U[UVGO QT 6JKU FGXKEG OC[ PQV ECWUG JCTOHWN KPVGTHGTGPEG CPF EQPPGEVGF FGXKEGU QT VQ CXQKF CEEKFGPVU YKVJ KPLWTKGU QT FGCVJ 6 JKU FGXKEG OWUV CEEGRV CP[ KPVGTHGTGPEG TGEGKXGF KPENWFKPI
