User's Manual

- Power supply : 6V 4cell Dry battery
- Current drain : 100mA
- Output power : 100mw
- Modulation : 2.4G AFHSS Single Directional
- LITE4 2.4 transmitter is equipped with servo reversing on all channels.
- If you need to change travel direction of rotation, open the battery case and
move the servo reversing switch.
- The unique open-stick assembly provides fully adjustable stick tension to adjust
the feel of the sticks in your hands.
- You may adjust the stick tension of your sticks to provide the feel that you like for flying.
To adjust your springs, you'll have to remove the rear case of the transmitter.
Using a screwdriver, remove the six screws that hold the transmitter's rear cover into position,
and put them in a safe place. Gently ease off the transmitter's rear cover and move it to the
under side of the transmitter, carefully turning it as you would turn the page of a book.
Now you'll see the view shown in the illustration.
Using a small Philips screwdriver, rotate the adjusting screw for each stick for the desired spring tension.
The tension increases when the adjusting screw is turned clockwise,
and decreases for counterclockwise motion.
When you are satisfied with the spring tensions, you may close the transmitter.
Very carefully reinstall the rear cover. When the cover is properly in place, tighten the six screws.
- The length of the non-slip control sticks can be adjusted to suit the requirements of the user.
AB
LITE4 2.4 Lever Tension
Tension adjusting
screw
4
LITE4 2.4 Instruction Manual
C. Specifications
D. Servo Reversing
E. Control Stick Adjustment
F. Stick Lever Tension Adjustment