User's Manual

14
H. S. REV (Servo Reverse)
S. REV (Servo Reverse)
When you first turn on your model, you will immediately see whether all the control surfaces are moving in the correct direction when you wiggle the controls.
If any are moving in reverse, you can come to this screen to reverse the throw of the offending servo.
Normal
Reversed
Reversing a Servo
Let's say your elevator is going down when you pull back on the joystick, that is definitely not going to be a good situation when you go to fly your plane!
To reverse the elevator servo, come to the switch in front of the radio’s front panel. You'll notice that the symbol NOR and REV,
move the switch either NOR or REV to make the servo operate in the proper direction.
V.TAIL (V-Tail)
I. V.TAIL (V-Tail)
This is another built-in mixing program available on the LITE4 2.4 that mixes the rudder and elevator servos for controlling V-tailed aircraft.
Similar to elevon programming, the two surfaces can move up and down together (for elevator control) or opposite (for rudder control in this case).
Setting Up a V-Tail
1) Activate the function by pushing the pre-programmed switch to the right.
2) With your model turned on, check your servo travel directions (both rudder and elevator channels) to be sure they are correct.
Use the REV switch if necessary to make the correction.
Surfaces can move up and down together (for elevator control) or opposite (for rudder control in this case).
CH2 CH4
CH2 CH4
Up Elevator Right Rudder (view from rear)
NOTE:
When you select V.TAIL, the ELVN program is rendered unavailable.
When you change the function of ELVN to V.TAIL or V.TAIL to ELVN,
Please TURN OFF THE TRANSMITTER FIRST and then change the function.
If you change the ELVN and V-TAIL functions when the transmitter is ON, nothing will be changed.
V-TAIL
OFF
ELEVON
H
3 CH4
REV
NOR
2
.4GHz 4 Ch
Link
V-TAIL
OFF
ELEVON
CH1 CH2 CH3 CH4
REV
NOR
2.4GH
z
LITE4 2.4 Instruction Manual