User's Manual

V-TAIL
OFF
ELEVON
H
3 CH4
REV
NOR
2
.4GHz 4 Ch
F. Trim Adjustment
This is a function for setting the trim values for each of the servos, allowing you to make adjustments to each individual servo independently of the
trim switches located near the control stick of the radio (which can be adjusted in flight).
We recommend that you first set up the model's servo pushrods so that the control surfaces are as centered as possible mechanically before
attempting to adjust them in the trim switch. We also recommend that you try to keep all the trim values at the center position. If the values are
skewed to once side, the servo's full range of travel may be restricted.
ELVN (Elevon mix)
Setting Up Elevons
If you are setting up a tail-less delta or flying wing aircraft, you can use this program to activate the pre-programmed elevon mix that mixes the output
on the CH 1 aileron and CH 2 elevator servo channels.
As you will notice in the servo connection chart, you plug one aileron servo in the receiver's channel 1 slot and the other aileron servo into channel
2-the slot that usually feeds the elevator.
This is necessary because on these wing types, the ailerons must double as elevators.
G. ELVN (Elevon Mix)
1) Activate the elevon function by pushing the pre-programmed switch to the left. Now check your model to see what happens when you move the
right-hand joystick side to-side. The ailerons should go up and down appropriately.
Move the joystick forward and back to see if the ailerons both respond correctly as elevators.
If necessary, use the REV function to reverse an offending servo.
2) Now set the amount (and direction if necessary as noted above) of each servo-both as ailerons and as elevators.
Because flying wings are extraordinarily pitch sensitive (because the elevator control surface is so close to the airframe's center of gravity),
you generally need the elevator travel and adjust horn linkage hole to be much less than that of the ailerons.
Front view
CH1 CH2
Aileron Operation
Elevator Operation
NOTE:
When you activate ELVN, note that the V-tail mixing is rendered unavailable by the radio.
When you change the function of ELVN to V.TAIL or V.TAIL to ELVN,
Please TURN OFF THE TRANSMITTER FIRST and then change the function.
If you change the ELVN and V-TAIL functions when the transmitter is ON, nothing will be changed.
13
Trim Switch
CH4
REV
NOR
LITE4 2.4 Instruction Manual