User's Manual

F. Mixing
• The Laser series transmitters are equipped with a switch that will mix ch.2 & ch.4
for V-tail vehicle or ch.1 and ch.2 for Elevon.
(Show illustration of the switch and the nice illustration used in the Eclipse manual on
pages 25 for v-tail and pg. 24 elevon function)
G. Control Stick Adjustment
• The length of the non-slip control sticks can be adjusted to suit the requirements
of the user.
(Show Illustration of stick like on pg. 6 of the Eclipse manual)
H. Gimble Tension Adjustment
• The unique open-stick assembly provides fully adjustable stick tension to adjust
the “feel” of the sticks in your hands.
• You may adjust the stick tension of your sticks to provide the “feel” that you like
for flying. To adjust your springs, you’ll have to remove the rear case of the
transmitter. Using a screwdriver, remove the six screws that hold the
transmitter’s rear cover into position, and put them in a safe place. Gently ease
off the transmitter’s rear cover and move it to the right side of the transmitter,
carefully turning it as you would turn the page of a book. Now you’ll see the view
shown in the illustration. Using a small Phillips screwdriver, rotate the adjusting
screw for each stick for the desired spring tension. The tension increases when
the adjusting screw is turned clockwise, and decreases for counterclockwise
motion. When you are satisfied with the spring tensions, you may close the
transmitter. Very carefully reinstall the rear cover. When the cover is properly in
place, tighten the six screws.
(Show Illustration)